Wuxi Huipu Auto Parts Factory

Wuxi Huipu Auto Parts Factory

Tel: +86-13914100185

E-mail: sales@wxhuipu.com

Contact US
Address: 50m West of Health Road, Donggang Town, Xishan District, Wuxi City, Jiangsu Province, China
TEL: +86-510-88350093
FAX : +86-510-88766081
Website: www.huipuautoparts.com
                
Home > knowledge > Content
Disassembly and installation of audi VW rear shock bump stop
- Jan 10, 2019 -

 The rear suspension assembly is an important part of the Audi Volkswagen rear shock absorbing system. During the disassembly process, the whole part is first removed, and the decomposition inspection is performed in order. After the disassembly of this part is completed, the damaged shock absorber assembly and the various rubber parts are replaced, and the spring can be compressed by a drop lift or a tow as it is installed. The next step is to install the rear axle and rear suspension.

 

The installation of the rear axle and rear suspension sections of the audi VW rear shock bump stop can be carried out in the reverse order of disassembly, but there are some things to be aware of. The first is to lay the parking brake cable on the exhaust pipe and then attach the rear axle to the vehicle body. Then install the shock absorber support rod seat into the bracket of the body and fix it with a nut.

 

It should be noted that in the audi VW rear shock bump stop installation process, the rear axle beam must be laid flat, and the angle between the body and the beam should be kept within an appropriate range. Replace all self-locking nuts and tighten to the specified torque.

 

https://www.huipuautoparts.com/